NAME

       dlt_gateway.conf - DLT configuration file for gateway

DESCRIPTION

       The configuration file dlt_gateway.conf allows to configure the different runtime behaviour of gateway in
       Multinode feature.

       The configuration file is written in an INI file format and contains information about different connect‐
       ed passive nodes.

       If  Multinode  feature  is  enabled,  dlt-daemon  loads  by default the configuration file /etc/dlt_gate‐
       way.conf.

       An alternative configuration file can be loaded by changing GatewayConfigFile in dlt.conf(5).

GENERAL SECTION

   Interval
       Time interval for reconnection to passive Node in second.

              Default: 1

PASSIVENODE SECTION

       Each passive node’s connection parameters are specified in a unique numbered separate section

       ([PassiveNode{1,2, ...N}]).

              Example: [PassiveNode1]

   IPaddress
       Because TCP is the only supported communication channel,

       the IPaddress and Port of the Passive DLT Daemon has to be specified.

       IP Address of passive node.  Mandatory

   Port
       TCP port.  Default 3490 is used if no port is specified.

              Default: 3490

   EcuID
       ECU identifier of passive node.  Mandatory.

   Connect
       With the Connect property it is possible to specify when the Gateway DLT Daemon shall connect to the pas‐
       sive node.

              Default: OnStartUp

       The following values are allowed:

              OnStartup   The Gateway DLT Daemon tries to connect to the Passive DLT Daemon
                          immediately after the Gateway DLT Daemon is started.
              OnDemand    The Gateway DLT Daemon tries to connect to the Passive DLT Daemon
                          when it receives a connection request.

   Timeout
       Stop connecting to passive node, if not successful after 10 retries.

       After of retries, the connection to passive Node is marked as DISABLED.

       It means there is no any retry anymore.

       Set to 0 for endless retry.

              Default: 10

   SendControl
       Send following control messages after connection is established.  Optional.

              Default: disabled

       Supported Control messages:

              DLT_SERVICE_ID_GET_LOG_INFO                    0x03
              DLT_SERVICE_ID_GET_DEFAULT_LOG_LEVEL           0x04
              DLT_SERVICE_ID_GET_SOFTWARE_VERSION            0x13

   SendSerialHeader
       Send Serial Header with control messages.  Value in dlt.conf(5) is used as default if not specified.

              Default: disabled

   SendPeriodicControl
       Send following control messages periodically.

              Default: disabled

       Format:

              control:interval[in seconds]

AUTHOR

       Thanh Bui Nguyen Quoc (thanh.buinguyenquoc (at) vn (dot) bosch (dot) vn)

COPYRIGHT

       Copyright (C) 2020 Advanced Driver Information Technology, Bosch and  DENSO.   License  MPL-2.0:  Mozilla
       Public License version 2.0 http://mozilla.org/MPL/2.0/.

BUGS

       See Github issue: <https://github.com/COVESA/dlt-daemon/issues>

SEE ALSO

       dlt.conf(5), dlt-daemon(1)

                                                                                             DLT_GATEWAY.CONF(5)